07-13-2008 10:48 PM
by Dick, & Barb Cain |
3 comments »
I ripped 2 X 6’s in half, & ran a 1/2” radius on all of the edges.
I also routed a 1/2” deep groove by 1 1/2” wide, to fit the balusters.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~Fitting railings to posts! Photos by Barb!
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~First baluster
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~Balusters all done, & taking a breather.
~~~...
Read this entry »

07-13-2008 07:49 PM
by Dick, & Barb Cain |
3 comments »
I finally got the 2” X 6” for the balusters.
Photos by Barb.~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~It took approximately 10 minutes to cut out a baluster, Then I rounded all of the corner with a 1/2” radius bit.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~Piled up ready to apply.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~First one!
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~...
Read this entry »

07-13-2008 07:17 PM
by Dick, & Barb Cain |
2 comments »
I’m kind of working backward, because you usually put the skirting on last,
but I didn’t have the 2’ X 6” material for the railing balusters yet, so that’s why I went this route.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~I didn’t want to rely on the bolts alone to hold up the deck,
so I rabbeted a 4” x 4” to rap around the metal post.
Photos by Barb!
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~...
Read this entry »