01-30-2013 04:52 AM
by Todd A. Clippinger |
5 comments »
I just finished up the video for applying edge banding to melamine. This video follows Part 1 on how to get clean cuts in melamine, which can be quite a challenge without the right blade and techniques. Once the melamine is cut, often it will need to have edge banding applied. So I cover this topic in Part 2.
I could have made a 2 minute video that shows me applying a piece with an iron and trimming the excess, but that can leave a person with a lot of questions.
In these videos, you no...
Read this entry »
06-23-2012 03:23 PM
by MoshupTrail |
10 comments »
So you’ve finished your back splash and it’s beautiful! But there’s still a problem. All your plugs and switches are now recessed by 3/8 to 1/2 inch. So you run down to the store and buy these stupid little spacers, right? WRONG! Don’t even think about it. A bag of these spacers cost’s $5-6 and might be good for 4 switches. You’ll need at least two bags for all those extra switches you’ve just installed. Also, the kind I tried were a little to...
Read this entry »
