Not sure what the right tool is for the job? This forum is the place to discuss tools and other resources available to get the job done right.
| Topics | Replies | Last post |
|---|---|---|
Dirlling in marbleI need to mount a piece of marble overheard that is about 2×36x5/8. I w... |
2 | 05-28-2018 12:16 PM |
Thrilled about the Dewalt.I collected most of my tools from harbor freight. It’s not that I ever ... |
4 | 05-28-2018 12:15 PM |
Sick of painting by hand. Anyone use sprays?I have painted and clear coated all the trim and doors before being installed... |
7 | 05-28-2018 12:00 PM |
Is the Paint Zoom even worth looking at?My lovely bride and I are remodeling out 1984 home, and with that comes a LOT... |
3 | 05-28-2018 11:36 AM |
Spray on Primer?Hey everyone … just jumped over from the lumberjocks site and had a que... |
3 | 05-28-2018 11:35 AM |
Inexpensive 2D software - easy to learnI have read a few comments here about the need for a drawing package. I just ... |
3 | 05-28-2018 11:34 AM |
Router TableI have a Ryobi A25RTG02 router table. The leading edge of my board keeps hitt... |
4 | 05-28-2018 11:24 AM |
How do I go about prepping wood for edge joing boards...without a jointer? I have been looking at a few used 6” jointers, but i... |
4 | 05-28-2018 10:21 AM |
Paint sprayerShopping for a new paint sprayer. Any suggestions as to most reliable brand? ... |
5 | 05-27-2018 12:06 PM |
blade height adjustmentI have a table saw that is very similar to a Rockwell brand. The blade heigh... |
4 | 05-27-2018 12:06 PM |
Easiest tape roll hanger everElsewhere I saw where someone was complaining that tool bags these days rarel... |
10 | 03-19-2018 01:56 AM |
