HomeRefurbers

vinyl siding starter strip

« back to Interior Home Improvement forum

Topic by stud posted 11-09-2009 02:48 PM 4201 views 0 times favorited 1 reply Add to Favorites Watch
View stud's profile

stud

1 post in 4174 days

11-09-2009 02:48 PM

How does one determine where to put the starter strip when applying vinyl siding? Is it a matter of dividing the height of a piece of siding into the overall height of the structure and putting the strip on that mark.



View devans0's profile

devans0

4 posts in 4170 days

11-13-2009 12:20 AM

When I put my siding up, I used a three inch board repeat so that I did not have to work it to an even siding board, just to an even repeat, and cut off the extra three inches. there was an inexpensive hand tool that punched through the siding to create tabs that would go into the top strip with the tabs holdiing the siding.

I was very careful to get the starter strip on exactly level. It made everything else fall into place. I’ve seen others fight every board to try to fix a bad start, and they still end up with a poor job.

You must be signed in to reply.

DISCLAIMER: All views and comments posted by members are not necessarily those of HomeRefurbers.com or of those working on the site.

Latest Projects | Latest Blog Entries | Latest Forum Topics

LumberJocks.com :: woodworking showcase